Crucial Exams

CompTIA A+ 220-1101 (V14) Practice Question

A technician is troubleshooting an FDM 3-D printer that repeatedly shows warping: the center of each print adheres but the outer edges lift from the build plate. The bed is level, clean, drafts are minimal, and the part-cooling fan is set to a low speed for the first layers. Which of the following is the MOST likely cause of this problem?

  • Model sliced with 100 % infill density

  • Nozzle replaced with a 0.2 mm diameter tip instead of 0.4 mm

  • Z-offset set too close, excessively squashing the first layer

  • Uneven heat distribution across the heated bed

CompTIA A+ 220-1101 (V14)
Hardware
Your Score:
Settings & Objectives
Random Mixed
Questions are selected randomly from all chosen topics, with a preference for those you haven’t seen before. You may see several questions from the same objective or domain in a row.
Rotate by Objective
Questions cycle through each objective or domain in turn, helping you avoid long streaks of questions from the same area. You may see some repeat questions, but the distribution will be more balanced across topics.

Check or uncheck an objective to set which questions you will receive.

Wipe Score
Bash, the Crucial Exams Chat Bot
AI Bot